Corbin Russwin - Alarm Kit ED50AK
Activation
Alarm is armed by turning key clockwise.
Low audible chirp indicates alarm has
been activated. Alarm will sound when the
exit device pushpad is depressed. Factory
preset for standard alarm mode which
automatically resets after 5 minutes.
Continuous Alarm Mode
Alarm sounds continuously when the exit
device pushpad is depressed. Alarm must be
manually reset by keyswitch. (This feature is
selected by a switch on the circuit board.)
Low Battery Warning
Audible chirp. Every 30 seconds.
Warning Decal
“EMERGENCY EXIT-ALARM WILL SOUND”
provided.
Nuisance Alarm
Units are factory preset for instant alarm.
Selectable feature for alarm to sound when
exit device touchbar is depressed for more
than 2 seconds. (This feature is selected by a
switch on the circuit board.)
Kit
Available in kit form for field retrofit except
surface vertical rods. Order ED50AK.
Arming Delay/Authorized Egress
A 10-second delay (after arming) permits
egress (by turning key clockwise).
Power Requirements
One 9-volt battery
Alarm Strength
90db @ 10 feet.
Arm/Disarm
Requires one 1-1/8" A02 cam mortise
cylinder. Clockwise turn arms the alarm,
counterclockwise turn disarms or silences
the alarm. Low audible chirp indicates alarm
has been activated.
Device Status
A Red LED indicator will illuminate every 30
seconds when the alarm is armed.
Tamper Resistant
Built-in safety monitor sounds alarm when
tampering occurs.
Cylinders
Mortise 1-1/8” A02 Cam. Cylinder not
included unless specified.
Door Width
Available for 36”-48” devices only. Not
available with devices less than 36”.
48" device can be cut to fit 42"-48" door.
The ED50AK for the ED5000 series exit devices cannot be retrofitted in the field to the ED5400/5470 series surface vertical rod exit devices.
Finish: 689 Silver Aluminum Painted